Search the forums
Loading
Glue underlayment to concrete subfloor
Glue underlayment to concrete subfloor (post #205654)
Chuck5 on Sat, 01/21/2012 - 17:37
I have radiant floor heat inbedded in light weight concrete on the second story of my house and want to glue underlayment to the concrete. I have been reading a lot of similar posts but they are able to screw into the concrete. I can't for fear of hitting the radiant heating tubes. Any recommendations on adhesives and just how flat does the light weight concrete need to be. Oh, my finished floor will be Armstrong vinyl composite tile. (not the self-stick) Thanks for your help.
Forum Topics
Breaktime
Project House Q&A Photo Gallery General Discussion Construction Techniques Energy, Heating & Insulation Business Tools for Home Building Green Building Reader Classified Help Wanted Work Wanted Breaktime Fests The Woodshed Tavern The ArchivesHelp/Feedback
Forum Suggestions Feedback on Fine Homebuilding The Editor's CornerInspired House
General Discussion Reader Tips Interior Decorating Design Talk Building and Remodeling Ideas Kitchen and Bath Outdoor Living Material Choices Photo GalleryCurrent Issue
Member Visits
kxt499990
-
46 min ago
Hammer1
-
50 min ago
weweesky07
-
57 min ago
OverKnight
-
2 hours ago
rich1
-
2 hours ago
calvin
-
3 hours ago
spaceghost
-
3 hours ago
Fonzie777
-
3 hours ago
Albany_Chris
-
3 hours ago
DanH
-
4 hours ago

All How-To Topics
































Can't you put the vinyl tile (post #205654, reply #1 of 3)
Can't you put the vinyl tile directly on the concrete?
We are like tenant farmers chopping down the fence around our house for fuel when we should be using Nature's inexhaustible sources of energy -- sun, wind and tide. ... I'd put my money on the sun and solar energy. What a source of power! I hope we don't have to wait until oil and coal run out before we tackle that. --Thomas Edison
Two adjoining floors are (post #205654, reply #2 of 3)
Two adjoining floors are about half an inch higher than the concrete. Tile in one room and engineered hardwood in the other.
chuck (post #205654, reply #3 of 3)
is this the same room (laundry) that was a problem in your other post?
You should have left these questions in the previous thread-background would have been taken care of .
but, if a small space-to add a qtr inch-maybe 1/4 inch tile underlay-bed it in PL premium or look to bostik for a proprietary adhesive (better idea) to glue it down. Hit the seams and surface (skim coat it) with Dependable crack filler. Light sand and put down your vinyl tile.
or, leave lower, install a transition pc at the openings.
A Great Place for Information, Comraderie, and a Sucker Punch.
Remodeling Contractor just outside the Glass City.
http://www.quittintime.com/