In the process of framing a recessed ceiling. Required to put LED lighting on a recessed edge. So, the question is
what is the appropriate depth for the recessed shelf. Thanks
In the process of framing a recessed ceiling. Required to put LED lighting on a recessed edge. So, the question is
what is the appropriate depth for the recessed shelf. Thanks
Ford Motor Company slashes prices for some F-150 Lightning models to stimulate demand for electric vehicles (EVs).
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Get home building tips, offers, and expert advice in your inbox
Fine Homebuilding
Get home building tips, offers, and expert advice in your inbox
© 2024 Active Interest Media. All rights reserved.
Get home building tips, offers, and expert advice in your inbox
Become a member and get instant access to thousands of videos, how-tos, tool reviews, and design features.
Start Your Free TrialStart your subscription today and save up to 81%
SubscribeGet complete site access to expert advice, how-to videos, Code Check, and more, plus the print magazine.
Already a member? Log in
Replies
LED strips I have are only 1.5" by 1.75 inches, and the driver (looks like small ballast) onl 2" by 1".
Recessed shelf
thanks for the info....my main concern is aesthetic. To shallow and the lights might be seen from the floor area. To deep might hinder light diffusion. Anybody have experience with these concerns.
thanks
LED'S...
... are where lighting technology's going, for sure. Problem now is there's so many variables in their fabrication (size, lensing - if any, wattage vs. lumen output, color temperature...) without knowing what specifics instrument (fixture) you're working with, no convincing arguement can be made for any opinions you might get on this.
Were I in your position I'd look to build a mock-up by which I, with the client being present, could get some idea of how these fixtures perform in an installation such as you've described. Then you can tweak the mock-up if need be to better suit your client's expectations.
Keep in mind that if you make the recess too deep you can shim it out somehow, but it's harder to recover from making it too shallow.
LED lighting
very good point...thanks!!!
,
Yeah, with LED lighting being in its infancy I'd figure that the components are apt to be replaced 10 years from now with new stuff that is not the exact same form factor. So leaving wiggle room (including, eg, a screwable surface at the back of the niche for its entire length) is probably a good idea.
We make a lot of these out of 2 X 4" and crown molding. Typically we use single bulb florscents for the main lighting and Led strips for mood lights. I buy the 16' strips from Amazon for about $4.00 each with drivers for about $8.00 each. They are very small and have adhesive backs. I just removed the florscents from a kitchen and used 3 strips of LEDs all around to match the wattage of the florscents. The customer loves them althought they are a little dim for me. They are cheap lights and as such I don't expect to get 20 years out of them but my experience so far has been that they'll go for at least 5. I priced name brand 16' Leds at a lighting store at $160.00 each so for the $150.00 savings we can just replace the strips when they burn out. They are available ina good range of K tempertures too.