*
Workmate maxed out the keyless chuck on mw cordless and drove screws allday.Now I cant get the chuck to close no matter how hard I grip it.Any suggestions on how to loosen jaws again?
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
This series of connected-barn-style structures have been rebuilt and updated for a modern feel.
Featured Video
Builder’s Advocate: An Interview With ViewrailHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
*
Ken, I've got a Bosch/Skil with the same prob...Pipe wrench channel lock combo, have to do it every time, tho...
* Phill Giles "Jammed Jacobs" 9/5/01 10:56pm
*Thanks guys.Pipewrench and channellocks worked fine.
*Ken,I had that problem with my 18v Dewalt. Took it to the tool repair shop, they replaced the chuck with a $45 jacobs. Dewalt considers occasional rubbing against drywall to be "abuse" so doesn't cover the chuck replacement.Moral-don't let your chuck rub against anything, it will go and go...I've beat the bejeezus out of that drill since then. Use it every day. No further problems.MD
*Ken... I had the same problem with my 18 volt Dewalt.I used channel locks pipe wrench trick for a while then one day I noticed there is an allen screw in the chuck..it has a left hand thread ...turned it a few turns (to tighten?) ...solved my problem,works like a new one now.