Discussion Forum
-
Makita and/or Dewalt Impact Driver
Ok I have both in 18v. Love both of them. However the issue I'm having is this: 1) Either the scrw heads shred/tare out. Regardless of head type. i.e square,…
-
Vinyl Siding question
Looking to all of you for advice. Looking to side my house and one contractor has quoted based on a vinyl siding called Variform. I googled it and didn't find…
-
Vinyl siding
Anyone ever hear of a vinyl siding company named Royal Crest? Samples say they are part of the Royal Building products. Good/bad?? All comments appreciated. Barney<!----> <!----><!----> <!----> <!----> Its not…
-
mdf trim
Ok, in the process of doing the trim work on a small renovation project at home. I'm using 8" high mdf base board. Its actually quite a nice profile. I'm…
-
Advantek vs. plywood
Getting estimates for our addition and was contacted my one of the contractors today. Wanted to know if I wanted an estimate for plywood or Advantek flooring. Anyone provide advice…
-
Re-introduction
I thought I would re-introduce myself. Its been quite a while since I set up my profile. When the site switched over, I lost all my previous posts. I've been…
-
Bostich nails
Has anyone run it not this lately? Bought the Bostich angled finish nailer and now its getting difficult to find the nails anywhere local. Lowes near me doesn't carry them…
-
pneumatic hose
Might seem like a lame question, but I'm in the market for a new airhose for my nail guns. Too many guns to convert over to a paslode. So, I…
-
Shingles
Looking at having the roof on our house replaced. Debating between Timbertech and Certanteed. Either choice will be dimensional. Any thoughts? Thanks Barney
-
plumbing question for a new addition
Ok, the wife and I are starting the process of obtaining quotes for an addition. One of the contractors is trying to talk us into the following for plumbing supply…