Discussion Forum
-
Laminate trimmers
In the market for a new trimmer, looking at the bosch and porter cable models. Have some jobs coming up that justify a new tool purchase, (hate when that happens---grin).…
-
Malco turbo shears ?
Need to cut some archs or radius smooth sweeping curves, was wondering if the shears that attach to my cordless will give me a nice clean cut in metal coil…
-
Cargo trailer for sale
Very good client of mine has a 16' by standard width, with additional 1' headroom trailer he would like to sell. Tandem axle, dark green, rear door, side entry. Trailer…
-
Compressor took a crap, advice needed
Compressor stopped cycling today, has been working fine. Only change that was made backed pressure down, ran good for about a hour and stopped cycling. Motor turns on but no…
-
Mystery water heater leak
Water heater (gas) seems to be leaking on the floor of basement. Problem can't find the leak. Put demand on system still can't see any leak. Drain cock is tight,…
-
recommendations for drywall banjo
Just signed a job to do some hang and finish, drywall. Figure its time to get a banjo, they all seem bascially the same ,put mud and tape in the box start spreading.…
-
gas leak repair van
Old customer of mine has given me the oppourtunity to take a full size van off his hands with very favorable terms for me. Apparently there is a small gas…
-
Roto zip – bosch
Bought a roto zip 5 yrs. ago came with the grinder head attachment, found it great when using the diamond blade for tile work, as the blade is fairly thin…
-
Another MDF ?
Just recently finished up a trim job using MDF beadboard 3/4" floor to ceiling entire condo and home depot 5/16" bead mdf panels for ceilings and one bath received the…
-
Corian sink plumbing ?
Customer switched out some cask iron vanitys, for new corian counters and undermount sinks. Question Existing tailpiece will not work, as cast iron had a hub on bottom and overflow was able…