Discussion Forum
-
Deck Pitch
Need to replace some rotting 4X4 deck posts on a sagging deck. (Posts are embedded in concrete piers). The deck is attached to the house, screened, and has a shingled roof. …
-
Deck Post Repair Questions
Need to replace rotting 4x4 posts sunk into concrete footings. Best way to jack it up? Should I dig the posts out of the concrete then fill with concrete and bolt…
-
Best Saw blade for Cutting MDF?
Need to cut some MDF on the Table Saw. I've got a variety of blades to choose from. Which blade is best for a smooth cut? Thank You
-
Best material for a router table fence?
I need to make a fence for my router table. I've several magazine articles with plans. Some use 3/4" ply, some use MDF, and some use Maple? Your experiences and…
-
Need to buy a workshop air cleaner
I need to buy an air cleaner for my basement workshop. It's not enclosed and the whole basement (and my lungs) are fair game for saw dust. I typically use…
-
Poplar Edging
I'm making a router table out of 3/4 ply with an MDF top (real simple) and wanted to provide some protection for the all the edges (sides and top). I thought…
-
Use a Miter Saw Blade in a Table Saw
Is it wise to use an 80 Tooth Miter saw blade with a 6 degree negative hook angle in a table saw for cutting cabinet grade plywood?
-
Woodsmith vs Shopnotes
What are the formats of the 2 mags. I'm getting Woodwmith and just picked up a copy of Shopnotes. How would you compare them to each other?
-
Exterior Trim Corner boards
I'm about to replace some rotten exterior corner boards with Azek. I'm not sure what's underneath i.e house wrap or tar paper. In either case should I cover the corner…
-
Replacing Rotten Corner Boards
Some of the pine corner boards on my house need to be replaced. I want to use Azek. It's a 2 story Colonial. Is it practical or a good idea…