Discussion Forum
-
Curved deck board question…
I'm looking for suggestions on how to transfer the profile of a curved deck fascia to the topside of the deck boards. I marked and cut the 'S' curve on…
-
One last Hardi Plank question
I have one final question in regards to installing Hardi Plank siding. I've read confliction info in regards to nailing into a stud for butt ends. I believe it was…
-
Cutting aluminum on a table saw?
Okay..so I posted a question about making 6" aluminum fascia work with 4 1/2" fascia boards and this brings up the question: Could one safely (and with good results) reverse…
-
6″ aluminum fascia retrofit question
Hello all...I'm wondering what is common practise for wrapping new 6" aluminum fascia over existing 4 1/2" fascia boards (or any size difference for that matter)? Even with the new…
-
Making a path with concrete molds
Has anybody had any luck using the plastic 2 X 2 concrete molds available on the market? I know Quikrete has a couple different styles as do Lee Valley (they…
-
Canuck looking for FC shears..
Any Canucks out there have a good source on FC shears or even better the Malco drill attachment? I'd appreciate any leads. I'd also be interested in 'used' if anyone…
-
Butt joints in Hardi Plank with shears?
Hello everyone, I've read most if not all the posts in regards to cutting C.F. board and everybody seems to agree that shears are the way to go vs. circ…
-
Contemporary fireplace – any thoughts?
Hello all, I am looking for any suggestions on how to finish the wall around a gas insert I recently installed. The fireplace front sits flush with the living room wall…
-
Best way to patch in hardwood flooring?
I'd appreciate any tips on patching in some new pieces to an existing hardwood floor. The existing oak flooring is pre-finished 3.4" T&G and I now have an open plywood sub-floor area where I…
-
Concrete counters anyone?
Hi everyone...thought I'd re-open an existing thread after reading some of the previous info from Mongo and others. I am having new cabinetry delivered at the end of the month and I…