Discussion Forum
-
Hows-bout this flashin’ tecneak
This had to been the biggest discount roofing job of the century. I was actually there to do a kitchen install and peeked out the bathroom window to just get…
-
Hilti Foam gun parts–
I hooked up with my local Hilti guy and was crabbin' about the plastic plug comin' off the needle and how I needed to order one to get it back…
-
Mitremike needs mitre clamps–Collins?
I have had enough with hanging cabinet crown and all the jockeying to line one end up and go to the other to mark it. So moved to the "Top…
-
Rockler–6″ Irwin clamp deal
Was by my local Rockler today and saw this great deal on Irwin 6" Quick clamps-- Included the link but they are available at the stores also-- Usually these are…
-
TJI’s as header material?
So this is just a point of interest and I know I'll tap the well on this one. If 2x10 solid sawn are used interchagable for floor joist and header…
-
New neighborhood store–caskets?
In a nearby stripmall this place opened up back in the spring--haven't had the guts to go check it out yet--afraid of what I might find-- Wonder if they are…
-
Chalk box fine line trick
Hello all--since chalk boxes seem to be the topic of the day I would like to share a trick I have for tight fine lines-- Works great for me laying…
-
Customize bench grinder speed?
I have a 6" delta bench grinder and it run 3450 rpm--So here is the question---I have some parts cleaning to do with a nylon disk--Alum motor parts....Can I wire…
-
Dewalt Impact Driver For Sale
I have a seriously nearly new 14.4 impact driver with all Batt. case etc. that I received as a bonus from a store owner that I like but my cordless…
-
Newest addition–Of the baby type
Hello all- On behalf of Tammy and I ---Here is our son Noah Michael born Fri. morning at 7:23 am all 9 1/2 lbs of him with his sister Sarah,…