Discussion Forum
-
cutting concrete paving stones
I need to trim a dozen 12 X 12 X1 concrete "stones". I have a 4-1/2" Hitachi dry masonry saw. Can I cut through the stone in one pass or do I…
-
Sealing concrete patio furniture
DW recently bought a table & benches for the patio that are cast concrete. Is there any kind of sealer I can put on them to keep spalling and cracking…
-
Cabinet Venting ?
We have a small wine cooler, 20 X 18 X 20 inch. DW wants it built into a cabinet. Does anyone have a clue about how much ventilation I'd need?…
-
Senco compressor wiring
I have a Senco P1130 hot-dog oil-splash compressor. 2 months past the end of the warranty. Motor doesn't quite get up to speed before the breaker trips. I tried a…
-
another dumb tile question
I recently finished tiling a tub surround, SWMBO had me add a 4" wide strip of decorative tile around the surround. Turns out, this decorative strip isn't "hard glazed" and…
-
lead-free solder
It's been quite a few years since I assembled any copper plumbing, is there anything special I need to know when using the lead-free solder vs. the old 60-40 solder?…
-
Tile countertop
We have a bathroom sink cabinet with an mdf top, SWMBO wants a tile counter. What's the best way to do it? Kerdi? Hardi-backer? Any suggestions on installing tile on mdf…
-
tub surround removal
I have a plastic tub surround that's held on with construction adhesive. Is there an "easy" way to remove it or is crowbar & muscle the only way?
-
Tile floor
SWMBO wants a tile floor in the foyer, I'm new at this. Do I need to leave a gap at the edges like you do with hardwood flooring? Thought I…
-
Dryer duct
I have a friend in North Idaho with a problem. The laundry room shares a wall with the garage. The contractor is adamant about not venting the (electric) dryer into…