Discussion Forum
-
Laminate surface variation on 45 degree miter.
What is considered an acceptable variation between the edges on the, top surface, of a 45 degree miter joint, when joining pre formed laminate counter tops? Virginbuild
-
Moisture meter suggestion
Time for me to start installing hardwood flooring, cabinets and trim work. I want a moisture meter with good range, quality, accuracy, and reliability. Anybody have a suggestion based upon experience with…
-
Box Newel Miters Opening Up
I just received a statement for a completed stair and railing job. Here is a picture that shows problems with the box newels. What should I expect the craftsman to…
-
Best pneumatic flooring nailer
I am going to purchase a pneumatic flooring nailer and am looking for advice on a good machine. It will be used for 3/4 inch hardwood and maybe for composite…
-
Wilkening Fireplace experiences
I am looking for first hand sharing of experiences and pros/cons of the Wilkening Fireplace. I am looking to have one installed in my house. I am looking for installation…
-
Average length of 2 1/2 inch strip floor
I am trying to find out what is the average length of 2 1/2 inch hard wood strip flooring. I find that some suppliers are selling mixed lengths in bundles…
-
Polaris water heater
I am asking for input from Polaris water heater users and service personal about the reliability and efficiency of the product. I would be using LP for fuel and using the…
-
Drywall Panel Lifts
I am looking for input on drywall panel lifters, especially from people working with them in the field. I am aware of two products available, the American made "Tele-Pro" and a model…