Discussion Forum
-
A big thanks.
Just wanted to say thanks. A little over 4 years ago I undertook a major project by my standards. I added 800 plus square feet to our tiny two bedroom…
-
Joe Fusco Website
Hello. Its been a good while since I have posted on here. I purchased some ebooks from Joe's website and then found out he had past away last year. R.I.P.…
-
Landscape lighting and tranformer dimmer?
Hello. Been awhile since I posted on here. Can a dimmer be used to control the exterior 110v outlet which a landsape lighting tranformer is plugged into? I want to…
-
6 3/8 or 6 1/4 reveal?
Hello. I'm sure most of you have read my other Hardi questions but here is another question on the layout. If I do the 6 1/4" reveal on the siding…
-
More Hardi Questions.
Hello. Just to be sure. Do butt joints on Hardiplank siding have to fall over studs? My walls are sheathed with 7/16 osb which according to Hardi is okay, but…
-
Colonial Smooth Siding starter strip?
Hello. I am about to finally install my colonial smooth hardi siding on my addition but can't seem to find out if the colonial smooth requires a starter strip at…
-
Exterior Door R.O.? Too much?
Hello. Home much is too much when it comes to the r.o. and door jamb spacing? I am about to install one of my exterior doors and the r.o. dimension…
-
16 ga. for Hardi Soffit?
Would 16ga.nails be too small to hold up Hardi soffit? What do you guys use? Thanks
-
Exterior door frame location.
Hello. Should a 4 5/8 exterior door frame extend past the exterior sheathing and interior studs on a 2x4 wall or should one side be flush? Thanks
-
I can’t cut straight!!!!!!
I need some help cutting mitered soffit corners. I'm putting up my soffits and cut a couple at 45 deg. and my cuts are not that straight. My mitered corners…