Discussion Forum
-
who treats workers best
During our break the other day the question of who treats workers in their homes better....New money or Old money? We refined the question a couple of times but basically…
-
Cordless finish guns
My Hitachi twin tank compressor seems to be getting heavier every time I take it out of my truck? My wife told me to start lifting weights. I'm thinking more…
-
Tar paper or Water & Ice
Getting ready to put some new shingles on my roof and I was thinking of laying water and ice over the whole roof. Obviously there is a cost consideration, but…
-
Insulating a slab before framing
I am planning on turning my "garage" into a family room. What is the general consensus as far as insulating and framing for the floor? I was thinking of framing…
-
Azek -To Glue or Not
My post today concerns the use of Azek 1/2 x 5 T&G Beadboard. We installed it in an addition to a kitchen, on a cathedral ceiling. Two skylights and about…
-
Home slicker
Alright, how about this....Has anybody even used home slicker at all? How about cedar breather? Just trying to get feel for this stuff. I'm afraid this product may cause the…
-
Home Slicker
Has anyone used Benjamin Obydykes home slicker under Hardie board fiber cement siding? I'm thinking of using the smooth Hardiplank lap siding 7 1/4 (6" exposure). I would use the…
-
Termite shield and sill insulation
My question is: Do you put the sill sealer (foam) under the termite shield , or on top of the shield? Some say the sealer needs to be next to…