Discussion Forum
-
Aluminum soffit vent
Anyone have a source for a punched aluminum sofit vent like the attached picture? I sourced this out about 6-7 years ago because it was the cleanest, best looking soffit…
-
Curved flashing
What are the different options for fabricating/installed curved flashing in a situation like the one below?
-
How would you design this entry
Haven't been here in a while, but thought I'd check in. I'm coming up blank on what to do with this entry. My plate has been full (fortunately) so…
-
Building an arched screen door – attn: FatRoman
Steve, this one's for you as requested. I finally am somewhat settled in my new home so I've got a little breathing room now. I haven't been here at BT…
-
Roofing tar for basement waterproofing
I'm remodeling a basement that gets a few trickles of water every year. I'm going to tackle some grading issues outside that I think will alleviate most of the direct…
-
Cellulose insulation holder in thingy
I'm looking for some woven fabric that I've used before in the past to hold in cellulose insulation in a new wall construction situation. It may have been some sort…
-
Arched arbor
Unfortunately didn't take many during photos because I was working against the weather most of the time, so every minute was precious! For the arches I glue-lammed rough 2" x…
-
Floor sander for deck….
Waddya think? I've got some folks with about a 1200 sf deck with 10 year old weathered cedar decking. It's not the best stuff, but they're thinking about trying to…
-
Pocket screws for glued up counters
Just a curious thought. Whenever I do glue ups of table tops or countertops, I just glue them and/or add biscuits or dominos. Never had any problem except with gluing…
-
How do you use your shop vac?
Just a random question. I've got 3 shop vacs, a 12 gallon shop vac brand, a Fein Turbo II, and a Festool ct22. If I'm doing anything cleaning wise I…