Discussion Forum
-
Fantech exterior mount kitchen exhaust
Hello. Fantech makes an exhaust box that mounts on outside wall. I'm looking into this because motor can't be found to replace the original that is worn out. Motor repair…
-
home made battery pack?
The old, cheap portable dvd player will not charge any more. The label says 7.4v 3500 mAh on the battery cover. Corded power is 12v dc. It looks like I…
-
bath faucet
Looking for wide spread polished brass bath faucet under $200. I found Danze from efaucet.com. I've heard of both names before, but wanted to hear from others too. What do…
-
durock membrane post
There is a post asking if durock is a good material. Nobody is answering and my thoughts did not post. Anybody use this? My 2 cents is that it looked,…
-
electrical question
I had wired the bathroom switch with 14-2. This was fine as long as I used the mechanical switch, but I would like to change that to a electrical timer…
-
generator: supply air, exhaust and fire extinguisher
Hello. Thank you for all the answers you've given in the past for my generator installation. The generator is portable 5000 watt Honda, gas engine. The original plan was to…
-
pulling through conduit
Hello. I asked about transfer switch before, and thank you for your advices. Generator is finally here, but the where it is going to be installed has been changed. This…
-
240v outlet
Hello. I am rewiring 240v through the wall a/c. It had 20 amp, 250v round outlet with horizontal slots and a ground hole. The a/c is in the kitchen and…
-
house water pressure reducing
Hello. I see 2 ways to solve water pipe banging - reducing valve or using ball valve. I hesitate using the reducing valve because it has many parts and especially…
-
generator set up
I would like your view on self installed generator set up. I am not electrician but I have installed new circuits. I've talked to 2 electricians so far. One was…