Discussion Forum
-
elliptical door fan
Thanks for the help to date. I am now in the process of building the fan. I am not sure if I am doing something wrong with the sizing or…
-
azek
I am redoing square columns on the front of my house. The original were 1-13/16 thick pine. I have been unable to locate anybody in my area that carries pine…
-
Router bit choice
I have finally constructed the jig to cut out an ellipse using my plunge router. I am planning on cutting it out with several passes. I am looking for which…
-
Flush trim router bit
I am looking for advice regarding cutting out an elliptical shaped piece of 3/4" MDO using as my final step a flush trim bit, router and router table. Do people…
-
Best exterior nail hole filler
Filling nail hole in trim and recessed nail in cedar siding. Any suggestions for a reliable, exterior nail hole filler. For the clapboards, would you prime first, then fill the…
-
epoxy filler
Using "sign" board (mdo) to construct a piece that will be outisde. What epoxy would people suggest to seal/fill the edges? Thanks for any help/suggestions. Kieran
-
Fan Decoration Over door
Sorry to keep asking basic questions on this. I am attempting to reconstruct the wooden fan detail over my front door. The detail has an elliptical shape and the molding…
-
Fan decoration over door
I am replacing the wooden fan detail over my front door as part of redoing all the rotted woodwork around the door. . Does anyone have any suggestions as to…
-
pneumatic nailers
Replacing the old exterior crown molding on my house. I figured this is as good an excuse as any to purchase a larger pneumatic nailer (have a small PC brad…
-
Nicad Battery repair/reconditioning
I know I read here or over at Fine Woodworking about a reliable place to send old Nicads from cordless tools to get them reconditioned. Search has not turned up…