Discussion Forum
-
Need help in wiring Nest E w/o C wire
I am trying to wire a Nest into a gas heater. I have a 24amp transformer with two wires that plugs into a wall outlet. I assume one wire plugs…
-
Rigid 3/4″ hammer drill augur bits loosen
I am trying to use this to drill holes to plant bulbs. The bit loosens almost immediately. Is there a way around this or is something wrong with the collett.…
-
Drill bit stuck in DeWalt 20v Impact Driver
A 1 1/4" wood bit is stuck. I was putting a lot of pressure on it drilling in an oak stump. DeWalt (ontario, ca) will usually fix something like this…
-
How to hollow a stump quickly…chemicals, drills, saws?
My mighty oak fell do to wet, heavy winter. As an experiment I would like to try and plant a blanket flower in the center (drip feed and see if…
-
DeWalt 735 Planer difficult to adjust for thickness
I haven't called DeWalt but I wanted to see if members had any tips. I bought this new (theoretically) from a person who re-sells Home Depot equiptment. The thickness crank…
-
Need 3″ offset flange for toilet
Plumbing contractor placed vent stack only 9" toilet opening. I need an offset flange of 3". I can't find one online, most don't give offset dimensions but measure 1 1/2"…
-
Trying to create maximum water pressure in shower
I am trying to develop maximum shower pressure to run a waist high(and head high but not at the same time) valve to squirt on my lower back. This is…
-
Knotty Pine Paneling: Do’s and Don’ts
I will be paneling a new construction small cabin (800 sq ft) and would like some advice on paneling (mainly to keep a check on the contractor who prefers immediacey…
-
How to remove sink from vanity base
I've found a vanity base that I like from Lowes with a sink already attached. I like the base but not the sink. Is there anyway to remove it? I…
-
How to insure work is done on time
I am soliciting bids for framing a cabin. I am getting estimates from 5 weeks (good) to 3 months. What leverage do I have that I can ensure work is…