Discussion Forum
-
Rigid foam ok for basement walls?
Im in the middle of a basement remodel and questioning the installation of 1" Rigid foam in my basement walls. The walls to be insulated are 4' under grade.... The…
-
Multi tool collar
Does anyone have any information on the universal multi tool collar that is supposed to come out? Is there a release date? Where will it be available, online or local…
-
Need help calculating a shower tile job.
Can someone give me a quick, general, cost per sq/ft on a stand up shower stall? Nothing fancy just a 3'X4" stall tiled 72" high with a curb in front…
-
horrible water pressure
I recently upgraded the plumbing in my house. I had 1/2" copper throughout the house from the holding tank to the upstairs bathroom. That was all replaced with 3/4" copper…
-
Venting a Propane water heater issue
I need to vent my propane water heater. It is located in my basement which had multiple points of air ventilation. Between the bulkhead doors and poor pointing in the…
-
low water pressure in bathroom
Im looking to get better water pressure in the shower of my mothers 2nd floor bathroom shower. It has been a trickle since I lived there many years ago. Where…
-
Epoxy finish on garage floor
Does anyone remember which FH had the article about the epoxy finish for garage floors? Also does anyone know if the epoxy used can fill a full thickness crack in…
-
Which issue was it?
I'm looking for an issue that had an article about spray foam insulation. I'm pretty sure it was middle to end of last year (07). Thanks, Dave. Is there an…
-
question about tiling marble
We have a room 12X12 that we want to finish the floor with marble tile. The tile is 12"X12" with a small bevel on the corners. As far as grout goes,…
-
galv screws…what happened?
I went to my local hardware store to get some galvanized screws for a deck and had to get a ceramic dipped screw instead. Did I miss something? What was…