Discussion Forum
-
Looking for a Paslode 16ga
Looking for a Paslode 16 ga Angle finish nailer. Could come in handy, but not at the list price. Anybody gots a good used one for sale??????
-
roof framing quandry
best choice for the facia boards or rim boards. Fascias are trim, just hanging out there. Rim joists are structural, occur at the wall, and take compression loads. Assuming fascias.....…
-
Location of freon leak
Heard a "rule of thumb" (from our AC guy) once: If a system (gas fires forced air) looses freon during the winter (or "down time") then the leak is in the Evap…
-
Heating-Bid a little high????
OK....here's the scenario. A friend owns an old home that is actually a "side by side duplex" w/ an apartment in the rear. Currently has one oil fired boiler (165000 btu)…
-
Help…$$ to install….
My son, the painter, has a customer that asked him if he would like to install some laminate flooring for her in addition to repainting the whole condo ( new…
-
Finishing a basement floor
Planning to re-finish my basement this winter. About 1000 sq ft with framed and paneled walls. Exist floor was glued down vinyl composition tiles (12X12). We removed all the tiles…
-
Dewalt 14.4 XRP torque settings
Bought a "refurbed" Dewalt 14.4 V XRP (3 speed) driver/drill as a backup about 4 mos ago ($139 at Toolcrib) Pulled it out to drill a 4 1/4 " hole…
-
Sulphur odor from water heater?
hello all I have a small (10Gal) electric water heater in my office (in the attic of all places). We have municipal water here, and the properties next door do…
-
Which (non auto-feed) screw-gun to buy
Hi guys, Got me a brand new SIL starting out in const business with his uncle. He wants to buy a "screw-gun" for drywall and decking etc (too much abuse…