Discussion Forum
-
laminate flooring
What is the trick to installing laminate flooring under cabinet toe kicks at both ends and perpendicular to the run?
-
crown moulding
Any suggestions for cutting crown moulding that has a base strip attached to it?
-
New Makita LSO714 7 1/2″ Miter Saw
I was wondering if anyone has one of these yet. I've been looking at the LS1O103 (10") saw. and this newer, smaller (7 1/2") model with the quad rods looks good.…
-
fiberglas batts
What's the scoop on installing fiberglas insulation batts, staple inside, or to the face. pro's and cons, behind a "install to the studs" shower unit (Sterling) on an exterior wall. What…
-
Very Small Bath Remodel
I need to move the toilet, left of it's original position, somewhere in the range of 3" to 6". What would be the best way to do this? I've considered…
-
Electrical puzzle???
While checking a another receptacle on the load side of a GFCI receptacle, I come up with the following: Testing with a "Wiggy" across the hot and neutral, shows "nada".…
-
two topics
Two questions please: 1.Insulating behind drywall on skylight shaft, can blue board be used ? thickness? 2.Framing a window opening at the ceiling level of 1st floor in a two…
-
enlarging sink cut out
I need to enlarge a sink cut out in a solid surface counter top. Can this be done with a router and whittled away at slowly?
-
hole in the wall
I have to knock a hole in a foundation/basement wall for a power venter. The size of the hole is about 7" square and will be in a wall with…
-
shower surround
I'm remodeling a very small bath with a built in shower, I'm saying the unit was very seldom used because it was surfaced with plastic tile. Because of the unusual size…