Discussion Forum
-
grout&paint concrete slabs
I’ve recently finished pouring my concrete shop floor. The design is concrete squares approximately 4' x 4', there are 40 of them. I intentionally scored each slab with an edge…
-
homemade trusses
Hey all, I've decided the best way to put the roof on my new 24'x36' shop/garage is to build my own trusses. I want to construct them in place, at…
-
Hitachi siding nailer
Hey folks, Any thoughts on the Hitachi NV75AG siding/framing nailer for a small time single man operation. I'd be doing some methodical frameing, wood siding, decking. It seems like the…
-
backerboard over slab
I found some messages about 3 years old about building up a slab under tile while searching in the FHB forum. And since it looks like this topic hasn't been…
-
sizing a compressor
Hey all, I'm about to buy a compressor (from Lowes) and was looking for advise on what the smallest compressor, in terms of CFM and PSI, I can buy that will comfortably…
-
Sizing a compressor
Hey all, I'm about to buy a compressor and was looking for advise on what the smallest compressor, in terms of CFM and PSI, I can buy that will comfortably handle a…
-
wood countertop
Anyone have any suggestions when it comes to finishing a wood countertop with Oil and not Poly or Varnish. I am installing a wood countertop of air dried, 1-inch, Wild…
-
Geodesic Dome roofing help?
Hey all, I've got a friend with a modern Geodesic Dome in need of a roof. It's about 12 years old, he's owned it for 2 years. All the skylights…