Discussion Forum
-
“rotten” hardie?
Has anyone encountered this type of "erosion" with Hardie? This particular area was run far to close (touching on some pieces) to the roof but I noticed other angle cuts…
-
deck to log…waterproof transition?
I'm looking to create a waterproof connection between a deck and log structure. The deck currently has a built up edge or "curb"...... a piece of 2X2 cant adjacent to…
-
tightening taps
Anyone have a suggestion on a tool or technique to tighten these nuts on a top mount bath sink.... the cavity is too narrow to fit either of my basin wrenches…
-
Greenglue?
Looking for some feedback....anyone used this product/system?? http://www.greengluecompany.com/
-
toilet bowl empty?
Hello All, Situation: 4 story, multi-residential, typical "stacked" bathrooms (common 4"cast waste stacks), no obvious cleanouts visible in suites, (4), 3pc baths in total on that stack with no drainage/toilet issues except…
-
test pic
Test picture....
-
undermount sink/granite install?
all, I have an kitchen undermount SS sink/taps to install next week and was wondering if any of you plumbing gurus had any helpful tips or advice. Thanks TN …
-
electrical/LV rough-in tips
To all: Just wondering if anyone has any tips or suggestions for roughing in electrical, data, cab/tel, A/V wiring etc. Just trying to avoid the, "I wish a had run another…
-
removing brick ?
Hello All, Looking for any advice on removing sections of brick from a building facade. What is the easiest/quickest way to do this. I have approx 2 sections, 2-3ft wide by…
-
Drywall corners – paper?
Hello all, Question on paper corner bead...what's the secret to setting outside paper corners??? I know the "pros" use a tool to "set" it in a bed of mud. Don't do…