Discussion Forum
-
Wall cap on poured in place wall
Poured a small concrete wall and want to mortar some real brick pavers as a cap.any need to wait for a 28 day cure?and ant suggestion if fortified mortar needed.thanks
-
Raised patio drainage
Have an existing concrete patio {8x12} 14” below sliding door. One step down. Want to do a patio extension and not remove the existing slab.so, the question. If I pour…
-
Chinese optical level
Some butt stole my good level and need a cheap replacement till I can severely pummel the guy who stole it. anybody ever tried on of those $60 plus jobs…
-
Raised patio on island
Southern Georgia. Hard packed sand soil. 2’ tall stacked block wall. Need base other than compacted sand?
-
Cutting Ipe
Need advice on blade for miter saw to cut Ipe. Have always used carbide but have never seen a discussion on the number of teeth for a good cut
-
Pocket door trim
I remember reading about trim on the picket side of a picket door being a brush material. guy said it kept dust and stuff out off the pocket and sealed…
-
2 piece base
When installing 2 piece base....square stock with cap....is there by reason to miter the inside corners on the squqre stock.
-
Metal frame door
CMU 1962 house. All interior/exterior doors are metal jamb with non movable hinges. Couple of questions. install metal/fiberglass door on entry. Does anyone sell exterior door blank that allows site…
-
Linear propane fireplace
Looking for advise on selecting a linear propane fireplace that is non heating. Decorative only. Thqnks
-
Sealing dryer vent
Installing a gas dryer in a new addition. Dryer is on exterior wall so will use a direct vent. exterior wall is spray foam insulation and already dry walled and…