Discussion Forum
-
Breaker Problem
Hi guys first of all I have been away for a looooong time. Nice to be back for the wealth of knowledge info and advice. I presently have a handyman…
-
Plunge router base
Does anyone know if the router base in the picture will accept a PC 690 motor. I want an additional plunge base for my routers and would like to have…
-
PC 8529 Speed control problem
Hi Everyone, I went to use my PC 8529 today which has very little time on it, and the router speed control is not functioning the router runs sporadically, and…
-
Dewalt Tracksaw initial impressions.
Hi everyone. My new tracksaw came today, thanks to a trial of Amazon prime with free two day shipping. I havent made alot of cuts yet, I have just set…
-
Dewalt versus Festool
Does anyone have experience with the Dewalt tracksaw? I am trying to decide between the tracksaw and the festool model. I have a large reception desk to build probly at…
-
Makita magnesium wormdrive saw. Pros and cons.
Hey everyone, does anyone have any experience with the new makita magnesium worm drive that came out a while back? I have the chance to pick one up used and…
-
GFCI and two wire wiring.
Hey all, My gf is buying an older home which needs updating. Some of the wiring is two wire. Will a typical gfci work on two wire applications? Two wire…
-
Countertop help p formed laminate.
I am just getting to replacing the counters at my parents house. Nothing fancy just stock laminate counters from Lowes. When the counters were delivered I noticed that the 10…
-
First tile work.
Hi all, I thought I would post a pic of my first solo tile work. I haven't posted a pic on here yet so here goes. The laying of the…
-
Dishwasher and tile floor.
I am in the process of tiling my kitchen floor. The cement board is down- 1/4 hardiebacker. When I measure from the cement board to the underside of the counter…